Tests and certifications were conducted by accredited third-party labs to ensure that this product performs as promised. PYROCHILL FIRE INHIBITOR is compliant to tests and certifications in accordance with:

​

• The regulations administered by the Consumer Product Safety Commission. The use pattern and exposure in the workplace are generally not consistent with those experienced by consumers.

• The requirements of the Occupational Safety and Health Administration applicable to this Safety Data Sheet meets the requirements of the CPSC and as a result, this SDS may contain additional health hazard information not pertinent to consumer use and not found on the product label.

​

CHEMICAL & PHYSICAL PROPERTIES​

• PHYSICAL AND CHEMICAL DATA DESCRIPTION: White, odorless, crystalline powder. BULK DENSITY: 48 lbs/cubic ft pH: 9.25 @ 20 °C (3% solution) MELTING POINT: 144 °F (62 °C) SOLUBILITY IN WATER: 5.8% @ 20 °C SOLVENT SOLUBILITY: Soluble in glycerol; very slightly soluble in alcohol; insoluble in acids.

• FIRE AND EXPLOSION DATA FIRE AND EXPLOSION HAZARD - Product is not flammable, combustible or explosive.

​

REACTIVITY

​

• FIRE FIGHTING MEDIA - Extinguish using agent suitable for type of surrounding fire. Product is fire retardant.

• FIRE FIGHTING - No acute hazard.

​

TOXICOLOGICAL 

​

• HEALTH HAZARD DATA NOTE: The acute health effects described below are those which could potentially occur for the finished product. They are based on the toxicology information available for the finished product. Known chronic health effects related to exposure to a specific ingredient are indicated.

• ACUTE HEALTH EFFECTS: INHALATION: Dust may cause mucous membrane irritation with coughing, dryness of the mouth and throat.

• SKIN CONTACT: Non-irritating to intact skin. Absorption through large areas of damaged skin may produce symptoms similar to those following ingestion.

• EYE CONTACT: Direct contact with powder or dusts may cause slight irritation with redness,

• INGESTION: May cause gastrointestinal disturbances such as headache and or diarrhea.

• CHRONIC HEALTH EFFECTS: No chronic health effects are expected from the intended use of these products or from foreseeable handling of them in the workplace. Moreover, a human study of occupational exposure to dusts showed no adverse effects.

• MEDICAL CONDITIONS GENERALLY RECOGNIZED AS BEING AGGRAVATED BY EXPOSURE: Pre-existing skin conditions and respiratory illnesses (such as asthma)

​

FIRST AID 

​

• EMERGENCY AND FIRST AID PROCEDURES FOR OVER INHALATION: Immediately remove from exposure area to fresh air.

• SKIN CONTACT TO OPEN WOUNDS: Rinse affected area with soap or a mild detergent and plenty of water until no evidence of product remains.

• EYE CONTACT: Immediately rinse eyes with plenty of water, occasionally lifting upper and lower lids, until no evidence of product remains. Get medical attention if pain or irritation occur.

• INGESTION: Treat symptomatically and supportively. Maintain airway and respiration. If vomiting occurs, keep head in a position to prevent aspiration of vomitus. Dilution by rinsing the mouth and giving water or milk to drink is generally recommended.

​

​

SDS/NFPA/OSHA/DISCLAIMER

​

The information contained herein is provided in good faith and is believed to be correct as of the date hereof.

​

Accordingly, PYROCHILL Solutions, Inc. will not be responsible for damages of any kind resulting from the use of or reliance upon such information. No representations, or warranties, either expressed or implied of merchantability, fitness for a particular purpose or of any other nature are made hereunder with respect to the information set forth herein or to the product to which the information refers.

​

DS CREATION DATE: 10/20/2022 SUPERSEDES:

12/29/2020 REVISION:

​

Due to the nature of this SDS, hazardous ingredient information, physical and chemical data have been provided as to the scope of protection under the laws, rules and regulations regarding corporate trade secrets.